m
small and handy
i was expecting a much bigger casing, but it is kinda small and does the job. more than enoughf for my little studio.
2
0
Report
B
Little Beast
Pros:
Insane value for what it is. I upgraded my headphones to Behringer DT990 PRO 250 and I needed to power them. This gets the job done phenomenally. The knobs work smooth and there is no friction "electronic" noise when manipulating them. Plus my workspace looks a bit more complex now with another device on my desk.
"Cons" (funny):
If you keep it in the same room you're sleeping in, the green led light might be pretty bright at night. (LEDs are plaguing my setup at the moment...). This little LED seems bright enough to light up the ceiling area above it at night. I guess you can cover it with any sticker.
Insane value for what it is. I upgraded my headphones to Behringer DT990 PRO 250 and I needed to power them. This gets the job done phenomenally. The knobs work smooth and there is no friction "electronic" noise when manipulating them. Plus my workspace looks a bit more complex now with another device on my desk.
"Cons" (funny):
If you keep it in the same room you're sleeping in, the green led light might be pretty bright at night. (LEDs are plaguing my setup at the moment...). This little LED seems bright enough to light up the ceiling area above it at night. I guess you can cover it with any sticker.
1
0
Report
A
Great for tracking a small band
Been using this little guy for tracking smaller bands and it does the job perfectly! It was a reliable and cheap way to get more headphone outputs to my interface.
0
0
Report
Z
Solid piece of gear
Very usable headphone amplifier/splitter for work in studio. Solid built, just like all other Mackie products.
0
0
Report
LL
Very happy
No colouration or loss of signal. Powers my old 600ohm AKGs perfectly
0
0
Report