Göldo MB05C Adapter Bushings

148

Adapter Bushings for Machine Heads

  • Makes it possible to mount vintage-style machine heads with a shaft diameter of 6.4 mm in a bore hole for enclosed machine heads of 10 mm
  • 6 Pieces
  • MB05C
  • Surface: Nickel
Available since July 2006
Item number 193586
Sales Unit 1 piece(s)
126 kr
Including VAT; Excluding kr200 shipping
In stock
In stock

This product is in stock and can be shipped immediately.

Standard Delivery Times
1

148 Customer ratings

4.5 / 5

You have to be logged in to rate products.

Note: To prevent ratings from being based on hearsay, smattering or surreptitious advertising we only allow ratings from real users on our website, who have bought the equipment from us.

After logging in you will also find all items you can rate under rate products in the customer centre.

quality

73 Reviews

TO
Great product - Just not the right fit
Tiago Oliveira Coelho 21.07.2020
Bought a set of Klusons for my Classic 60's Tele (MIM) to replace the Kluson-style Ping/Fender stock tuners, but the bushings were too narrow for the pre-existing holes. So I found these conversion bushings and thought my problem was solved.
Before anything, I have to say that they're quite good, and feel very solid. A+ for building quality.

However, the holes for the tuners in my guitar is neither 8mm nor 10mm. If you have the same model as I do, either be prepared to enlarge the holes on the headstock to fit these, or just use aluminium tape on the narrow bushings to keep them in place.
quality
0
0
Report

Report

t
My bad, they didn’t fit…
tremblox 07.01.2023
These are fine but didn’t fit my application. I’m writing this as a heads-up to others.
Firstly not all tuners, even Gotoh tuners have the same post/shaft diameter. Not even in the same series. Take for example the Kluson-style SD91 series. The units with magnum lock and height adjustable post/shafts - the HAP-M units - have 6mm post diameters. They fit too loosely in these bushings and as a result of the string tension the tuners will get sloppy and wear out prematurely over time.
On the other hand the standard SD91 tuners (no locking, height adjustment) have post diameters of ca 6,25mm (from memory so I might be off by a tad), so that these bushings will be a perfect fit and you’ll enjoy a lifetime of happiness with them.

So in all cases the buyer should check their post diameters carefully before selecting and trying to source the correct bushings. Take care, it’s a jungle out there.
quality
1
0
Report

Report

L
Does not fit all Gotoh locking tuners...
LeonardS 25.05.2021
I bought these to install the Gotoh SD-91-05M MG-T locking tuners as the bushing delivered with the tuners were too small for my Fender to fit well.
However, I can confirm that these Göldo MB05C bushings do NOT fit the tuners either as the diameter, like the Fender ones, are simply too small (narrow).
The Göldo MB05C go well with the other Gotoh SD-91 locking tuners, but for those the Fender bushings fitted as well.
The bushings themselves are ok.
quality
0
0
Report

Report

BC
Goldo adaptor bushings mb05c
Byrnes C 03.06.2020
did the job perfectly great for fitting vintage style tuners into 10 mil holes without messing up the guitar
straight forward fitting
quality
1
0
Report

Report